Today, we finally got the right bottom of the door weather seal—only not from Pella. We gave up on them after they crapped out after the third try to ship us the right seal. The third one was an even worse failure than the second. It was 51 inches long and the barbs were not spaced right.
I got transferred to a Pella Corporation supervisor who told me that the issue should have been handed to their service department long before it got so far into this circus of mistakes. So supposedly, the supervisor contacted the service department—who never contacted us. Apparently, the supervisor didn’t stay on the case to ensure we got the right item because we never heard back.
Pella just dropped us.
We finally found Hass Wholesale in South Bend, Indiana. The story is a little complicated. Evidently, Pella manufactured the bottom door seal we needed at an Ohio factory until around 2010 or so and then shut down the factory.
On the other hand, the invoice on the item we got from Cloud Brothers Wholesale LLC (evidently associated with Hass) identified it as “Pella-Pease 2/8 Bottom Sweep from (2001-2014 5/8” Kerf.” UPS delivered it.
The Pease company also makes their own door seals which would have fit our Pella door. They even call it a Pella seal. But they manufacture them and have nothing to do with Pella. They also don’t make them in the 32-inch length.
Both Pease and Hass sell Pella bottom drive on door seals just like the one we needed. I think Hass gets some of them from Pease. I don’t know what relationship they might have with Pella. Pella never commented on one of our messages indicating we were aware of Hass Wholesale inventory containing an item Pella apparently was not able to find in their own inventory.
Enough of them were available such that Hass Wholesale was able to ship us the right item 3 days after we ordered it.
Pella Corporation in Iowa fumbled the ball repeatedly for more than a month.
We give Hass Wholesale two thumbs up for a job well done. On the other hand, Pella Corporation customer service representatives (in Pella, Iowa no less) while friendly, couldn’t get the job done at all. Pella gets two thumbs down.
Of course, we were nervous about installing the seal, but it looked almost exactly like the old one and the measurements were spot on. The barbs didn’t run the whole length of the seal, but they really didn’t need to be that long. The important thing is that they were 5/8’’ center on center wide to fit the kerfs.
We were a little hesitant about doing the job today, because there’s a Heat Advisory (temperatures up to 105 degrees) and we had to take the entry door off the hinges and air condition the garage so to speak.
There was not much effort other than I used a rubber mallet to help drive the seal securely into the kerfs. I also hammered a couple of small nails into both ends. I didn’t need to adjust the height of the threshold. The door closed securely and the seal was snug.
We had to push towels against the entry door bottom for weeks and worried about bugs and energy bills, waiting for Pella to send us the right seal. We don’t have to do that now.
I have no idea how many people actually replace their bottom of the door seals. I wish them luck if they are on Pella doors. You might want to just go with Hass Wholesale to save time.